Canon SX 50 - Manual (Page 81)

Projector User Commands
- 75 -
Revision History / Date Changes Revised by Approved by
NOSIG
Display screen when no signal setting
Format
NOSIG=<Parameters for setting display screen in no-signal mode:ID>
Parameter
<Parameters for setting display screen in no-signal mode:ID>
For models other than SX7 Mark II
BLACK Black screen
BLUE Blue screen
LOGO User screen
For SX7 Mark II
BLACK Black screen
BLUE Blue screen
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the display screen when no image signals are input.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command has the same function as the buttons listed in the table below.
Model Menu
SX50 [Display settings] - [User screen settings] - [Screen in no-signal mode]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Display settings] - [User screen settings] - [Screen in no-signal mode]
(4) To select the user screen (LOGO), the user image must be registered ahead of time. (If the user image is
not registered, "e:1002 NO_LOGO_CAPTURED" is returned.) *However, this excludes SX7 Mark II.
(5) The GET command can be used to retrieve the current display screen at no signal.
For details, refer to the GET command.
Example
Setting
> NOSIG=BLUE This sets the “Blue” screen when no signals are input.
< i:OK
Reference
> GET NOSIG or ?NOSIG This retrieves the screen when no signals are input.
< g:NOSIG=LOGO
Acquisition of parameters which can be set
> RANGE NOSIG
< r:NOSIG=I, BLACK, BLUE, LOGO "BLACK," "BLUE" or "LOGO" can be set for the display screen
in the no-signal mode.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting