Get temp – Canon SX 50 User Manual
Page 172
Projector User Commands
- 166 -
Revision History / Date
Changes
Revised by
Approved by
GET TEMP
Temperature inquiry
Format
GET□TEMP
?△TEMP
Response
g:TEMP=<Number of temperature sensors:Number>,<Temperature measurement 1:Number>,
…,<Temperature measurement n:Number>
<Number of temperature sensors:Number>:=Number of temperature sensors (Number of measurement points)
<Temperature measurement n:Number>:=Temperature measurement of each temperature sensor
Range from 0.0 °C to 127.9 °C, 1 decimal place after the decimal point.
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the lamp lighting time.
(1) This inquiry can be made in any status provided that AC power is supplied to the projector.
(2) Temperature range from 0.0 °C to 127.9 °C can be acquired.
(3) For temperatures below 0.0 °C, 0.0 °C is acquired.
(4) If a temperature sensor error occurs, 0.0 °C is acquired.
Example
> GET TEMP or ? TEMP
< g:TEMP=6,25.2,27.1,24.1,26.8,26.0,25.6
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x x x x x x O
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 -
-
- - - - - - - - - - - -
SX6, SX60,
X600
-
-
- - - - - - - - - - - -
SX7,
X700
-
-
- - - - - - - - - - - -
SX7 Mark II O
O O
O
O
O
O
O
O
O
O
O
O
O
Reference