Reset, Projector user commands, Format – Canon SX 50 User Manual
Page 95: Parameter, Response, Description
Projector User Commands
- 89 -
Revision History / Date
Changes
Revised by
Approved by
RESET
Reset
Format
RESET□<Reset parameters:ID>
Parameter
<Reset parameters:ID>
LAMPTIME
Lamp on time reset
IMAGE
Current image adjustment reset
SYSTEM
Initial system settings(same as "Factory settings" in the menu)
ALL Initialize
all
Response
"i:OK" is returned if the reset process is successful.
Furthermore, the internal status established when a response other than the normal response ("i:OK") has been
returned is indeterminate. For details on other responses, refer to the "Error List".
Description
This resets the projector settings.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) What can be specified by the reset parameters for each "reset type" is provided below.
■
Reset of lamp on time
(a)The counter indicating the lamp replacement period is reset.
(b) This command functions in the same way as when "System setting" - "Lamp counter" - "Reset"
are selected on the menu.
(c) Execute this command after replacing the lamp.
■
Current image adjustment reset
(a) The adjustment settings of the currently-selected image mode are initialized.
(b) This command functions in the same way as when "Image adjustment" - "Image adjustment
reset" are selected on the menu.
* If there is an input signal, the image adjustment items are initialized and then the adjustment values are
optimized for the signal.
■
Reset of system settings
(a) The following items are initialized.
• Image adjustment items (all image modes)
• Initial settings executed
* For details, refer to 'RESET items' at the end of these specifications.
(b) This command has the same function as the buttons listed in the table below.
Model
Menu
SX50
[System settings] - [Initial settings]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[System settings] - [Other settings] - [Factory settings]
■
Initialize all
(a) The following items are initialized.
• Image adjustment items (all image modes)
• Initial settings executed
• Input source
•
Language
* For details, refer to 'RESET items' at the end of these specifications.
Notes
(a) The power must never be turned off while this command is being executed!
(b) After the 'Factory settings,' be absolutely sure to turn the power off and then restart.
(c) 'NO_SIGNAL' may be returned as the response to the command after 'Current image adjustment reset' or 'System initial
setting' has been executed.
Control