Canon SX 50 - Manual (Page 85)

Projector User Commands
- 79 -
Revision History / Date Changes Revised by Approved by
PMM
Power management
Format
PMM=<Power management setting parameters:ID>
Parameter
<Power management setting parameters:ID>
OFF OFF
STANDBY Standby
mode
EXIT Exit mode
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the power management mode.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command has the same function as the buttons listed in the table below.
Model Menu
SX50 [System settings] - [Power management modes]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[System settings] - [Power management modes]
(4) For models other thanSX50, Power management cannot be set to OFF if ON has been selected as the
direct power-on setting (DPON=ON). ("e:1005 DIRECT_POWER_ON" is returned)
(5) The projector behaves as follows with the power management setting and in the remote mode.
Model Projector behavior
SX50
In the remote mode, the power management setting is ignored.
This setting takes effect only when the local mode is established.
SX6, SX60, X600, SX7, X700,
SX7 Mark II
Even in the remote mode, the projector operates as per the power
management setting.
However, when it starts operating, it is automatically transferred to the "local
mode."
(6) The GET command can be used to retrieve the current power management mode.
For details, refer to the GET command.
Example
Setting
> PMM=STANDBY This sets the power management to "standby".
< i:OK
Reference
> GET PMM or ?PMM This retrieves the power management mode.
< g:PMM=EXIT
Acquisition of parameters which can be set
> RANGE PMM
< r:PMM=I, OFF, STANDBY, EXIT "OFF", "STANDBY" or "EXIT" can be set for the power management.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting