Get mode, Projector user commands, Format – Canon SX 50 User Manual
Page 153: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 147 -
Revision History / Date
Changes
Revised by
Approved by
GET MODE
Current control mode inquiry
Format
GET□MODE
?△MODE
Response
g:MODE=<Mode:ID>
<Mode:ID>
LOCAL
The local mode is currently established.
REMOTE
The remote mode is currently established.
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current control mode.
(1) For details on the control modes of the user commands, refer to the control mode.
(2) This inquiry can be made in any status provided that AC power is supplied to the projector.
(3) The control mode is usually switched by REMOTE command-LOCAL command, but when the next event
occurs in the remote status, the mode is switched to the local status.
a. When the POWER button on the remote control or main unit panel has been pressed twice
(power off operation)
b. When the power management mode has been established (standby, power off)
Example
> GET MODE or ?MODE
< g:MODE=REMOTE
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 O
O
O O O
O
O O
O
- - O O O
SX6, SX60,
X600
O
O O
O
O
O
O
O
O
O
O
O
O
O
SX7, X700 O
O
O
O
O
O
O
O
O
O
O
O
O
O
SX7 Mark II O
O O
O
O
O
O
O
O
O
O
O
O
O
Reference