Canon SX 50 - Manual (Page 25)

Projector User Commands
- 19 -
Revision History / Date Changes Revised by Approved by
6AXR-Y
6-axis correction R-Y hue/saturation settings
Format
6AXR=<R hue:Number>▽<R saturation:Number>
6AXG=<G hue:Number>▽<G saturation:Number>
6AXB=<B hue:Number>▽<B saturation:Number>
6AXC=<C hue:Number>▽<C saturation:Number>
6AXM=<M hue:Number>▽<M saturation:Number>
6AXY=<Y hue:Number>▽<Y saturation:Number>
Parameter
<Hue:Number>▽<Saturation:Number>
Setting values for hue and color saturation -20 to 20
The RANGE command can be used to obtain the parameter range that can be set at that time.
For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the 6-axis correction of the hue and color saturation for R to Y.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) These commands take effect when 6-axis adjustment (6AX) has been selected by the advanced color
adjustment command (ACADJUST) or when they have been set to valid using the 6-axis adjustment
command (6AXADJ), and they can be set separately.
(4) This command is the same as the menu functions in the table below.
Model Menu
SX50 [Image adjustments] - [Advanced color adjustments] - [6-axis color adjustments]
SX6, SX60,
X600, SX7, X700,
SX7 Mark II
[Image adjustments] - [Advanced adjustments] - [6-axis color adjustments] - [Adjustments]
(5) This sets the currently selected input signal and image mode.
(6) The GET command can be used to retrieve the current color adjustment values.
For details, refer to the GET command.
Example
Setting
> 6AXR=-8, 5 The R hue is set to –8, and the color saturation is set to 5.
< i:OK
Reference
> GET 6AXR or ?6AXR This retrieves the R hue and color saturation.
< g:6AXR=12, -8
Obtain settable parameter range (Min, Max)
> RANGE 6AXC
< r:6AXC=N,-20,20,-20,20 Any value from -20 to 20 can be set for the hueand saturation of the C
(cyan) color.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting