Rcch, Projector user commands, Format – Canon SX 50 User Manual
Page 93: Parameter, Response, Description, Example, Commands supported, Environment
Projector User Commands
- 87 -
Revision History / Date
Changes
Revised by
Approved by
RCCH
Remote control channel setting
Format
RCCH=<Remote control setting parameters:ID>
Parameter
<Remote control setting parameters:ID>
1
Remote control channel 1
2
Remote control channel 2
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This command is used to set the channel of the remote control used at the projector end to 1 or 2.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command has the same function as the buttons listed in the table below.
Model
Menu
SX50
[System settings] - [Remote control]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[System settings] - [Other settings] - [Remote control]
(4) The GET command can be used to retrieve the current remote control setting.
For details, refer to the GET command.
Example
Setting
> RCCH=1
This sets the remote control channel to ch1.
< i:OK
Reference
> GET RCCH or ?RCCH
This retrieves the remote control setting state.
< g:RCCH=2
Acquisition of parameters which can be set
> RANGE RCCH
< r:RCCH=I, 1, 2
"1" or "2" can be set as the remote control channel.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting