Range terminal, Projector user commands, Format – Canon SX 50 User Manual
Page 225: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 219 -
Revision History / Date
Changes
Revised by
Approved by
RANGE TERMINAL
Terminal setting option request
Format
RANGE□TERMINAL
Response
r:TERMINAL=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the parameter options which enable the terminal to be set.
(1) Inquiry can be made when the projector is in both the remote mode and power-on status at the same time.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) The terminal can be set by the TERMINAL command.
Example
> RANGE TERMINAL
< r:TERMINAL=I, IN, OUT
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O x x x x x x
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
Parameter
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
IN
O
O
O
O
O
O
-
-
O
O
x
SX50
OUT
x O
x
O
O
x x O
O
- - O O
x
SX6, SX60,
X600
- -
-
-
- - - - - - - - - - -
SX7,
X700 - -
-
-
- - - - - - - - - - -
SX7
Mark
II - -
-
-
- - - - - - - - - - -
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “TERMINAL_OUT” is returned with the Err
response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference