Canon SX 50 - Manual (Page 162)

Projector User Commands
- 156 -
Revision History / Date Changes Revised by Approved by
GET PROG
Progressive value setting inquiry
Format
GET□PROG
?△PROG
Response
g:PROG=<Set (status) value:ID>
<Set (status) value:ID>
Errors supported by model
Parameter Meaning
SX50
SX6, SX60,
X600
SX7, X700 SX7 Mark II
0 OFF O O O O
1 ON O O O O
2 AUTO x O O O
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current progressive (status) value set.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
It may not be possible to make this inquiry with some input signals.
(3) The significance of the response differs slightly depending on the model concerned.
Model Significance of response
SX50
Regardless of the progressive setting, "ON" is indicated when the current progressive
conversion processing function is working; "OFF" is indicated when the processing function is
not working.
Other than
SX50
This signifies the progressive value setting.
(4) The progressive setting can be selected by the PROG command
Example
> GET PROG or ? PROG
< g:PROG=1
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - x O x
SX6, SX60,
X600
x O x x x x O O O x x x O x
SX7, X700 x O x x x x O O O x x x O x
SX7 Mark II x O x x x x O O O x x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference