Power management mode, Projector user commands – Canon SX 50 User Manual
Page 20
Projector User Commands
- 14 -
Revision History / Date
Changes
Revised by
Approved by
7. Power Management Mode
Concerning the processing for switching to the power management standby or exit mode in the remote or local
mode.
Mode
SX50
SX6/SX60/X600/SX7/X700/SX7 Mark II
Remote
The power management standby or exit
mode is not established.
(No countdown is initiated.)
The power management standby or exit mode is
established when no signals are supplied for at least 5.
The countdown is aborted by any command other than
GET/RANGE.
Control is switched to the "local mode" in the standby or
exit mode.
Local
The power management standby or exit mode is established when no signals are supplied for at
least 5 minutes.
Projecting in
progress
Lamp
cooling in
progress
Lamp off
Power Off
Lamp on
Power management activated
Processing only for commands
enabled in power management
standby mode
When the standby
mode is established
When the exit mode
is established
Events for returning from standby mode
・
Signal input
・
Pressing of a button on main unit or remote control
・
REMOTE command
・
RC/MAIN command (excluding RC/MAIN*-REP)