Image, Projector user commands, Format – Canon SX 50 User Manual
Page 58: Parameter, Response, Description
Projector User Commands
- 52 -
Revision History / Date
Changes
Revised by
Approved by
IMAGE
Image mode setting
Format
IMAGE=<Image mode setting parameter:ID>
Parameter
<Image mode setting parameter:ID>
Errors supported by model
Parameter
Meaning
SX50
SX6, SX7
SX60
X600
SX7 Mark II
SX7 Mark II
DICOM MODEL
STANDARD Standard
O O O O O
O
PRESENTATION
Presentation O O O O O
O
CINEMA Cinema
O x x x x
x
SRGB
sRGB
O O O O O
O
ADOBE ADOBE
RGB
x
O
x
x
O O
MOVIE Movie
x
x
O
O
O O
MOVIE_PHOTO
Movie & Photo
x
O
x
x
x
x
HOME_CINEMA Home
theater
x
x
O
x
x
x
PHOTO
Photo
x x x x O
O
DCM_SIM DICOM
x x x x x
O
The parameters which can be set at any given point in time can be obtained using the
RANGE command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the image quality.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) The final settings for the image mode are retained even when the power is turned off.
(4) This command is the same as the menu functions in the table below.
Model
Menu
SX50
[Image adjustments] - [Image mode settings]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Image adjustments] - [Image mode settings]
(5) This command is the same as the menu functions in the table below.
Setting
Commands related to the settings
Remarks
Brightness BRI
Contrast CONT
Sharpness SHARP
Gamma adjustment
GAMMA
Dynamic gamma
DGAMMA
Progressive PROG
Screen color correction/RGB adjustment values WB/ WBRGB
For the SX50
Saturation/hue SAT/
HUE
Advanced color adjustment
ACADJUST
For the SX50
Memory color correction
MEMCADJ
For other than the SX50
RGB gain/offset adjustments
RGBGAIN/RGBOFFSET
For other than the SX50
6-axis color adjust
6AXR~Y
(6) The GET command can be used to retrieve the current image quality.
For details, refer to the GET command.
Setting