Projector user commands, Example, Commands supported – Canon SX 50 User Manual
Page 59: Environment
Projector User Commands
- 53 -
Revision History / Date
Changes
Revised by
Approved by
Example
Setting
> IMAGE=PRESENTATION
This sets the image mode to "Presentation".
< i:OK
Reference
> GET IMAGE or ?IMAGE
This references the current image mode.
< g:IMAGE=CINEMA
Acquisition of parameters which can be set
> RANGE IMAGE
< r:IMAGE=I, STANDARD, CINEMA, SRGB
"STANDARD", "CINEMA" or "SRGB" can be set as the image mode.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II
x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.