Projector user commands, Environment – Canon SX 50 User Manual
Page 53
Projector User Commands
- 47 -
Revision History / Date
Changes
Revised by
Approved by
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
x x x - - x O x
SX6, SX60,
X600
x
O
x O O
O
x x x O
x x O x
SX7,
X700
x
O
x O O
O
x x x O
x x O x
SX7
Mark
II
x
O
x O O
O
x x x O
x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.