Lang, Projector user commands, Format – Canon SX 50 User Manual
Page 67: Parameter, Response, Description
Projector User Commands
- 61 -
Revision History / Date
Changes
Revised by
Approved by
LANG
Language select
Format
LANG=<Language selection parameters:ID>
Parameter
<Language selection parameters:ID>
Errors supported by model
Parameter
Meaning
SX50
SX6, SX60, X600
SX7, X700
SX7 Mark II
ENG
English O O O O
FRA
French O O O O
GER
German O O O O
ITA
Italian O O O O
SPA
Spanish O O O O
POR
Portuguese
O O O O
SWE
Swedish O O O O
DUT
Dutch O O O O
RUS
Russian O O O O
CHS
Chinese
(simplified)
O O O O
CHT Chinese
(traditional)
O O O O
KOR
Korean O O O O
JPN
Japanese
O O O O
FIN Finnish
x
O
O
O
NOR Norwegian
x
O
O
O
TUR Turkish
x
O
O
O
POL Polish
x
O
O
O
HUN Hungarian
x
O
O
O
CZE Czech
x
O
O
O
DAN Danish
x
O
O
O
The parameters which can be set at any given point in time can be obtained using the
RANGE command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This switches the screen display language.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command is the same as the menu functions in the table below.
Model
Menu
SX50
[System setting] - [Languages]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[System setting] - [Languages]
(4) This sets the currently selected input signal and image mode.
(5) The GET command can be used to retrieve the current set language.
For details, refer to the GET command.
Setting