Canon SX 50 - Manual (Page 111)

Projector User Commands
- 105 -
Revision History / Date Changes Revised by Approved by
WB
Screen color correction
Format
WB=<Screen color correction parameters:ID>
Parameter
<Screen color correction parameters:ID>
NORMAL Standard
GREENBOARD Blackboard
ADJUST Adjust
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
The screen color correction is set to “Normal”, “Blackboard”, or “Adjust”.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command has the same function as the buttons listed in the table below.
Model Menu
SX50 [Image adjustments] - [Screen color correction]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Display settings] - [Screen color correction]
(4) When "ADJUST" has been selected, adjust the RGB adjustment values using the WBRGB command.
(5) When the model SX50 is used, the currently selected input signal and image mode settings are established.
When the model SX6, SX60 or X600 is used, a set of settings is established for the system.
(6) The GET command can be used to retrieve the current screen color correction.
For details, refer to the GET command.
Example
Setting
> WB=NORMAL This sets the screen color correction to “Normal”.
< i:OK
Reference
> GET WB or ?WB This retrieves the screen color correction.
< g:WB=GREENBOARD
Acquisition of parameters which can be set
> RANGE WB
< r:WB=I,NORMAL,GREENBOARD,ADJUST
"NORMAL," "GREENBOARD" or "ADJUST" can be set for the screen color
correction.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting