Xerox 7024 - Manual (Page 156)

REFERENCE
Canadian certification
The Canadian Department of Communications Label identifies
certified equipment. This certification means that the
equipment meets certain telecommunications networks
protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to
the user's satisfaction.
Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord.)
The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection the electrical
ground connections of the power utility, telephone lines and
internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural
areas.
WARNING: Users should not attempt to make such connections
themselves, but should contact the appropriate electric
inspection authority or electrician, as appropriate.
The load number (LN) assigned to each terminal device denotes
the percentage of the total load to be connected to a telephone
loop which is used by the device, to prevent overloading. The
load number is 13. The termination on a loop may consist of any
combination of devices subject only to the requirement that the
total of the load numbers of all the devices does not exceed 100.
This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of
Communications.
Cet appareil numérique est conforme aux limites d'émission de
bruits radioélectriques pour les appareils de classe A stipulées
dans le Règlement sur le brouillage radioélectrique du ministère
des Communications du Canada.
Load Number for terminal 23
Certificate Number CS03 - 7602
Certification Number 482 4107 A
9-4 TELECOPIER 7024 USER HANDBOOK