Xerox 7024 - Manual (Page 96)

RECEIVING
To automatically receive a document when an
answering machine is connected LOAD ORIG: (ANS)
This setting instructs your terminal to allow the answering
machine to answer all calls. You can also answer the calls
manually using the terminal handset.
The terminal offers a setting to automatically switch the call
from the answering machine to the terminal after 0-15 seconds.
(See Set TAD Time.) If the line is quiet (caller does not speak) for
the specified period of time, the call will be switched to the
terminal.
1. Remove any documents from the ADF and press [Manual
Receive] until the following displays:
LOAD ORIG: (ANS)
SEP 30'91 8:00
2. When the telephone rings, the answering machine will
answer. At this time, your terminal will listen for fax tones
and quiet time (0-15 seconds). If your terminal hears either,
it will switch from the answering machine to your terminal
and receive the document. If fax tones are not detected, the
voice message will play. After the voice message completes,
the remote operator can leave a voice message or press
[Start] to begin the send operation.
If for some reason the answering machine does not answer,
your fax will answer the telephone after 7 rings and
automatically receive the document.
The following displays when the terminal receives a
document:
INCOMING CALL
RECEIVE STD
Note: If the remote operator leaves a message longer than
1 minute, your terminal will not switch from the answering
machine to your fax.
5^ TELECOPIER 7024 USER HANDBOOK