Memory full, Switching the power off and on, Memory full -22 switching the power off and on -22 – Xerox 7024 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
preparing
the
machine
for
operation
2. Press [Select] a second time to display the percentage of
memory used.
MEMORY IN USE (023%)
_________
3. Press [Stop] to return to the original display.
Memory full
• When memory is full, an alarm sounds and an error message
appears on the display.
MEM FULL SEE MANUAL
ENTER/CLEAR
• If above message is displayed, press [Enter] within one
minute to save ail scanned originals.
Failure to respond within one minute results In the cancellation
of the job and the deletion of scanned originals. An Error
Message Report will be printed out.
Switching the power off and on
When the power is switched off, any document(s) in memory will
be deleted and pending delayed transmissions will be canceled.
The percentage of memory that is currently being used Is
displayed when [Select] is pressed from the idle mode. If any
memory Is used and you need to switch off the power, perform
the following actions to avoid losing the document(s) in
memory.
•
if a transmission is pending or a delayed operation has been
setup, the power should not be switched off unless
necessary.
•
If an error is displayed, correct the problem according to the
message.
•
A Pending Job List can be printed to determine if you need to
print the documents before power is switched off.
•
It is not necessary to turn the power off to change the
imaging film.
1-22
TELECOPIER 7024 USER HANDBOOK