Talkswitch CT.TS005.001101.UK - Manual (Page 70)

6 2 T A L K S W I T C H U S E R G U I D E • U K & I R E L A N D
one more ring than the number of rings you select. TalkSwitch uses the
first ring to determine the ring type and to support Caller ID
information.
Adjust Sequence.. (button)
This section controls how the Extensions will ring before the Auto Attendant
answers the call.
• If you have chosen the Auto Attendant to answer calls immediately, this
section does not require configuration and is grayed out.
• If the Auto Attendant is set to answer after 1 or more rings, configure
when specific Extensions ring before the Auto Attendant answers.
• If no Auto Attendant is selected to answer on the specified line, specify
when particular Extensions will ring up to 9 times. Remember
that no calls go to voicemail unless you first have an Auto Attendant
answer.
2.3.5.4 VoIP Numbers
First, select a VoIP number to configure. Then select the appropriate mode
for which you want TalkSwitch to use these settings. If you entered the
phone number in the VoIP Numbers section under System Information, the
number will appear on the corresponding button.
Remember: Callers are only directed according to settings for an Auto
Attendant. Calls do not follow the Call Cascade settings of any of the
Local Extensions programmed to ring before the Auto Attendant answers.
This section deals with how TalkSwitch with VoIP trunks will handle
incoming VoIP calls.