Ditch Witch JT60AT - Manual (Page 169)

JT60/JT60 All Terrain Operator’s Manual
Service - 169
Service Precautions
Working Under Drilling Unit
Use safety supports as indicated when working under drilling unit.
Before working under front end of drill frame, install jackstands under frame.
Before working under area of drilling unit supported by a stabilizer, make sure drilling unit is parked on
hard surface.
1. Remove cylinder lock pinned to frame (1) and place over extended cylinder rod (2).
2. Reinstall pins to secure cylinder lock to rod.
3. Raise stabilizer until load is supported by cylinder lock.
Before working under area of drilling unit supported by frame tilt cylinder, make sure drilling unit is
parked on hard surface.
1. Remove drill frame support tube stored under frame (3) and place under drill frame (shown in
inset).
2. Lower drill frame until load is supported by drill frame support tube.
Crushing weight could cause death or serious injury. Use
proper procedures and equipment or stay away.