Ditch Witch JT60AT - Manual (Page 203)

JT60/JT60 All Terrain Operator’s Manual
Service - 203
As Needed
Change Inner Water Swivel (Seal Kit)
Replace inner water swivel (seal kit) as needed.
See your Ditch Witch dealer for replacement
parts.
To replace:
1. Remove SaverLok connection. Do not
remove indexing dowels from spindle.
2. Remove hex (6) and spring (7) from drive
shaft.
3. Remove seal (4) and main body (2).
4. Inspect dowel pin (1). To replace, drive new pin into different hole until top of pin is flush with shaft
larger diameter.
5. Slide new main body (2) onto drive shaft. Replace o-ring (3).
6. Lightly coat seal (3) with SAE 30 engine oil and install onto main body.
7. Slide snap ring (4) onto main body.
8. Compress seal kit until snap ring is properly seated.
9. Install hex (5) and spring (6).
10. Install SaverLok. See page 202.
IMPORTANT: Use care when handling main
body to avoid seal contamination. Do not
allow grease to touch inner seals during
installation.
NOTICE: Do not run seals without lubrication. Damage will occur.