Cadac F-Type User Manual
Page 104
APP-VIII
F-Type
Revision F2005-2
6WDUW#)DGHU#0DS
(QG#)DGHU#0DS
$ERUW#)DGHU#0DS
The user has requested to Start, End (and store) or Abort (don’t store) Fader Map-
ping information.
These events have been placed into the Error Log after a user reported that his con-
sole was “re-mapping itself”. The logging of the events would allow you to know if
and when this happened.
8VHU#UHTXHVWHG#7HVWV
The CCM menu system offers a number of tests that may be performed to check that
the system is operating correctly. Some of these tests may present an error message
if they find a fault and this message may be recorded in the Error Log.
%XV#)DLOXUH#Q
This error may occur when the user requests “Test Comms” from the test menu in the
CCM. The CCM checks the four communications busses that it uses to control
motorized faders and if any are found to be faulty, it reports 1 for bus one failure, 2 for
bus 2, 4 for bus three and 8 for bus four. These numbers may be combined and pre-
sented as a hexadecimal digit if more than one bus has failed e.g. 6 means bus two
and three are faulty.