Cadac F-Type - Manual (Page 78)

6-6 Display Group module 7467
F-Type Revision F2005-2
914153 '&#0DVWHU#0XWH
When MUTE is ON the channel faders controlled by the DC group are indirectly
muted.
914154 5HDG\#/('
Press the Ready button when you are ready to send dynamic data to the PC (motor
faders only). No data is sent until Write mode is invoked by touching the fader knob.
A fader in RDY mode will respond to movements sent by the PC until the fader knob
is touched. The RDY LED will flash when data is being generated.
914155 ,VRODWH
When ISO is ON, the fader is in effect disconnected from the computer system. It
cannot send commands to the computer or receive commands from the computer,
but the fader still responds as a VCA master.
All faders, including DC Masters can be put in isolate mode by pressing the MOD-
ULE ISOLATE “SET” on the CCM. Similarly, all faders, including DC Masters may be
taken out of isolate mode by pressing the MODULE ISOLATE “CLEAR” switch on the
CCM.
914156 '&#0DVWHU#IDGHU
A 100mm Penny & Giles fader controls all channel VCA faders selected to it.
914157 )DGHU#23(1
The Fader Open LED illuminates as soon as the fader moves away from the infinity
mark, unless the MUTE function is set ON locally or under program control.