Cadac F-Type - Manual (Page 46)

2-18 Central Control Module 7896
F-Type Revision F2005-2
■ ■ ■ ■ The channel fader MUTE button only effects the main audio output from a chan-
nel
■ ■ ■ ■ When the AUX VCA switch is selected on a fader:
■ ■ ■ ■ The channel fader MUTE button affects the main and the post fader auxiliary
send signals from the channel.
Channel faders selected to a DC master fader will always “follow” the DC master
Fader. Channel and DC master faders may be programmed for “Snapshot” position
changes and can be used in dynamic cues.
0RWRU#IDGHU#EHKDYLRXU#ZKHQ#VZLWFKLQJ#EHWZHHQ#PRGHV
When entering or leaving Group-Link mode, the channel fader position will change if
it is assigned to a VCA group other than 0, and the relevant DC master is set at a
position other than 0dB
I, 7ZLQ#PDVWHUV
This option is used in the event that an external master fader box is connected to the
console. When “twins” are enabled, moving a Master Fader will cause its twin to
move in the same way. This allows a modicum of remote control.
■ ■ ■ ■ Using the arrow keys, select “Twin masters” in the menu “User Setup” and press
[ ↵ ].
■ ■ ■ ■ Select the number of Twin masters in the box, by pressing [
↵
] until the number
appears on the CCM display.
Press [Esc] to go back to the “User Setup” menu.
J, (YHQW#GXUDWLRQ
The Events-function allows control of external equipment, such as CD-players, tape-
decks, effects-boxes etc. via 8 relays within the CCM. These relays can be in one of
three states:
ON = always on
OFF = always off
PULSE = toggles between on and off
PULSE duration can be set to a value (1-25) as required to control the external
equipment.
■ ■ ■ ■ Using the arrow keys select “Event Duration” in the menu “User Setup” and press
[
↵
].
■ ■ ■ ■ The display shows “Event Dur: “
■ ■ ■ ■ Press [
↵
] again until PULSE is set to a value between 1-25 (25 = 3 sec).
Press [Esc] to go back to the “User Setup” menu.
K, 5HYHUW#0RGH
Revert Mode allows motor faders to return to their original positions if they have been
manually put in their position. The time they take to do this may be programmed (see
below) and the operating circumstances which prompt them to “revert” may be set
as:
OFF Function Off
RECORD Function enabled when recording a dynamic
REC/PLAY Function enabled when recording or playing back a dynamic
ALWAYS Function always enabled
The option ALWAYS is primarily intended for test purposes.