1 safe/ready/write – Cadac F-Type User Manual
Page 33
Central Control Module 7896
2-5
Revision F2005-2
F-Type
S,
.H\SDG
The numeric keys [0] to [9] and the decimal point [.] are used to select a particular
cue or memory number in conjunction with one of the function keys listed below.
Key
Meaning
Function
[Sys]
SYSTEM
Calls up the SYSTEM SETUP menu.
[Mem]
MEMORY
Selects one of the non-volatile internal memories.
[Clr]
CLEAR
Clears a selected memory (i.e. sets everything to
OFF)
[Err]
ERROR
Writes error message or information to alphanumeric
display.
[Esc]
ESCAPE
Moves backwards through a menu, or aborts an
operation, can be thought of as a “cancel” button.
[Bsp]
BACKSPACE Deletes the last number entered.
[Rcl]
RECALL
Recall a cue or memory.
[Sve]
SAVE
Store a cue or memory.
[
↵
]
ENTER
Selects a menu item, starts or acknowledges
operations.
The arrow keys, [
←
], [
→
], [
↑
] and [
↓
] are used to help navigate in the various menus.
The buttons are back-lit by LEDs, and will illuminate or flash to indicate that they will
perform a useful function if pressed at that time, or that their function has been
selected.
Unlabelled buttons are reserved for use in future software updates.
T,
35(9#DQG#1(;7#EXWWRQV
Use the previous or next button to recall snapshots from the automation cue list to
the console.
51414
6DIH25HDG\2:ULWH
The following instructions refer to the group of switches on the CCM labelled
“MOTOR FADERS”. See also
To put all motor faders in SAFE mode: Press “ALL SAFE” switch.
To put all motor faders in READY mode: Press “ALL READY” switch.
To put a small number of motor faders in READY mode:
a) Press the “SET READY” switch.
b) Touch each fader knob that is to be recorded and make fader movement required.
c) Press the “SET READY” switch (to cancel the function).