Cadac F-Type - Manual (Page 23)

Connecting the mixer systems 1-15
Revision F2005-2 F-Type
41816 &RQQHFWLRQV#0#5-78
Figure 1-10 below and fig 1-11 show how to connect the Seance box to the console
and the computers running SAM, using RJ45 connection.
41817 (WKHUQHW#0#5-78
The Seance box can also communicate with the PC via an RJ45 connector depending
on the type of Ethernet-card in the computer. The Séance box has two RJ45 connec-
tors, one for each PC interface. These connectors should be connected directly into
a computer. It is also possible to connect the RJ45 sockets to a hub. For details about
this, contact CADAC technical support.
41818 0RXVH
Each PC has a ‘one-to-one’ PS2 mouse cable, which connects between the PC’s
mouse port and the mouse connector on the rear panel of the Séance box. The
mouse plugs into the mouse connector on the front panel of the Séance box.
0RXVH
.H\ERDUG
9*$
3&4#ZLWK#(WKHUQHW#FDUG 3&5#ZLWK#(WKHUQHW#FDUG
0RXVH
.H\ERDUG
9*$
7R#UHPRWH#3.1
FIG 1-17. Séance rear panel connections for RJ45
0RXVH .H\ERDUG FIG 1-18. Séance front panel connections - BNC and RJ45