Cadac F-Type - Manual (Page 63)

Stereo Input module 7761 4-7
Revision F2005-2 F-Type
For full details on using the SAFE/READY/WRITE modes, see 2.1.1 Safe/Ready/
Write .
71415; ,VRODWH
When ISO is ON, the programmable switches on the module and the fader are effec-
tively disconnected from the computer system. The module cannot send commands
to the computer or receive commands from the computer. The module and fader
responds as though it was a non-automated sub-system.
All modules may be put in isolate mode by pressing ALL FADER ISOLATE “SET”
switch on the CCM. Similarly, all modules may be taken out of isolate mode by press-
ing the ALL FADER ISOLATE “CLEAR” switch on the CCM.
71415< 3)/
This electronically latching, logic controlled PFL button allows post EQ, post-insert
monitoring under the control of the osc/comms/monitor module.
714163 +H[DGHFLPDO#GLVSOD\
This display shows VCA group assignment in hexadecimal 0-9, A-C. 9 is unas-
signed.
714164 0XWH
A Mute-switch is included on each channel to allow the operator to instantaneously
switch off the audio signal without disturbing the fader balance.
714165 /('#EDUJUDSK#PHWHU
20-segment LED meter monitors channel level post EQ and INSERT point.
714166 )DGHU
A 100mm Penny & Giles conductive plastic fader controls the signal level through the
channel via a VCA circuit on the main audio sub board.
714167 )DGHU#RSHQ
The Fader Open LED (situated below the 20-segment LED meter) illuminated as
soon as the fader moves away from INFINITY, unless the following conditions apply:
■ ■ ■ ■ The fader has its local VCA MUTE set ON.
■ ■ ■ ■ The fader is being controlled by a DC Master fader set fully OFF.
■ ■ ■ ■ The fader is being controlled by a DC Master fader with its local MUTE set ON.
Flash WRITE As soon as the fader knob is touched, dynamic data
is sent to the PC. The fader will not respond to data
sent from the PC until the fader knob is released.
READY LED Mode System response