Cadac F-Type - Manual (Page 73)

Display Group module 7467 6-1
Revision F2005-2 F-Type
9 'LVSOD\#*URXS#PRGXOH#:79:
A standard group module contains one sub group and two Matrix groups (A and B).
Since each group is fully wired to an output connector, 36 separate outputs are avail-
able on a fully fitted console.
The sub group has an additional input that allows a line level signal to be injected into
its mixing amplifier; an output level fader with associated 20-segment LED meter;
switches for insert, PFL and Mute. Routing to 24 Matrix Groups is done via 24
potentiometers labelled 1A to 12A and 1B to 12B.
Each of the two Matrix groups has an output level potentiometer with associated 20
segment LED meter, plus switches for Insert, PFL and Mute.
All group modules use the same front panel and electronics. The different group
modules are denoted by individual sub group and Matrix group numbering on their
respective MUTE switches. Mixing bus coding is done by use “Bus coding” link
boards and the DC master fader number is set by DIL switches on the mother board
(see CADAC schematic drawing 7612 in the “Drawing Set”.
The 7467 is optionally available with a motorised fader.
The following pages describes the Display group module 7467 in detail.