JB-Lighting Licon 1X - Manual (Page 114)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 114 -
22.6.2 Changing the fadetime
Select the event as described above. Press the softkey CHECK to play the event within a loop.
Important: the softkey CHECK is now not only displayed inverted, but also designated as A-PLAY.
Enter the desired fadetime with the left encoder wheel (FADE -/+). When you have changed the fade time
successfully, press the softkey A-PLAY/CHECK to deactivate the event.
22.6.3 Editing events (cues and chases)
Select the event as described above. Press the softkey EDIT to enter the cue or chase editing
programme. Press the softkey MODIFY to activate the desired cue or chase. Change their DMX values
and store the cue or chase again. See also Chapter 6 Programming and storing cues.
Important: This function does not only change the data of the corresponding cue or chase in the timeline
mode, but also the data of the keys, on which the cues and chases have been stored previously.
22.6.4 Deleting one event
Select the event as described above. Press the softkey DELEVT to delete a single event.
Caution: you will not be prompled to confirm the deletion.
22.6.5 Deleting all events within a frame
All events located on a frame are referered to as position. In order to delete this position, select an event
of the frame as described above. Press the softkey DELPOS to delete the entire position.
Caution: you will not be prompled to confirm the deletion.
22.7 Playing a timeline show
A timeline show is played in the Timeline menu. Enter the main menu and press conscutively the softkeys
TOOLS and TILINE.
The timeline display shown below will appear on the display.
The softkeys have the following function:
CDPLAY:
gives access to control elements of the CD
player
PARAM: gives access to loop menu, as programming
aid.
PLAY: starts and stops the timeline show.
Pressing the key once will start the show from
the beginning „ 00:00:00 „ (softkey is
displayed inverted).
Pressing the key again will stop the
show as well as the music (softkey is no
longer displayed inverted).
-->PLAY: starts timeline show from a frame specified
previously.
A-Play: plays a previously defined part of the track
RECORD: gives access to the programming level of the Timeline menu.
EDIT: gives access to all editing functions.
BLOCK: defines blocks
Press the softkey CDPLAY and insert the music CD into the CD drive. Select the desired track with the
softkeys ---> and <--- .
Press the ESC key to leave the menu.
Then press the softkey PLAY to play the selected track. Make sure that the master faders and group
faders are raised.