JB-Lighting Licon 1X - Manual (Page 41)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 41 -
6.1.3 The cue keys in combination with the page/bank keys
The cue section has 24 keys that are distributed in three blocks of eight keys.
On each key of the first block (each key is labelled with a number from F1 to F8), a single cue can be
stored. This block is reserved for important cues that are often activated. The cue keys of the first block
cannot be switched with the Page/Bank function.
The keys of the other two blocks (each key is labelled with a number from 1
to 16) can be switched with the page or bank keys of the PAGE/BANK block.
Three pages and four banks (A to D) are available for each key. The page /
bank activated for the cue is signalised by a red LED.
As shown in the illustration, each cue key can be assigned to three pages
and per page to four banks. Thus, a maximum of 192 cues can be stored on
these 16 keys. If the cue keys from the first block (F1 to F8), which cannot be
switched, are added, then a maximum of 200 storage places is available.
Pages and banks are switched by activating the corresponding page or bank
key. The red LED of the particular page or bank keys begins flashing. The
LED stops flashing, if a cue key is pressed in addition.
When a cue was activated or stored, the following menu is shown on the display:
The illustration shows that cue key no. 5 on the third page,
bank D was activated.
6.1.4 Naming cues
Before a cue is stored, a name is assigned to it. The name may have a maximum of 13
characters. Press the softkey NAME until the field in the display is shown inverted and
enter a name for the cue with the double-assigned keys in the cue/chase/sequence
sections.
If the cue is already named, delete the characters with the arrow key.
After deletion, you can enter the cue name as described above.