JB-Lighting Licon 1X - Manual (Page 90)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 90 -
18.6 The numerical block (NUM)
The numerical block is used to activate combinations of PAR channels. Press the softkey NUM to activate
the numerical block. Since this function can be followed on the display, the middle master fader (C-PAR)
must be raised.
Activate the numerical block and the softkeys shown below in the illustration will appear on the display
Combinations of PAR channels can only be entered with the softkeys SEL + , SEL - and SEL
 together
with the keys of the CUES/CHASES/SEQUENCES section.
SEL +:
confirms entry of a single channel number
SEL - : confirms deletion of a single channel number
SEL : confirms selection of a channel block
% : entry of DMX values for the selected channels in percent
Example of how a combination of PAR channels is entered by means of the numeric block:
Important: Make sure that no undesired channels are addressed by deleting the current selection with the
softkey CLRSEL (no LEDs must be lit in the FIXTURE-/PAR-SELECTION section).
The desired block should consist of the channels 1, 7 and 32-46 with a DMX value of 50%.
Enter the data in the following succession:
Press Cue key 1
Confirm with softkey SEL+
Press Cue key 7
Confirm with softkey SEL+