JB-Lighting Licon 1X - Manual (Page 67)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 67 -
11.2.5 Page 5 of the chase generator (chase switching between more than two parameters)
A standard chase always switches between two parameters
(presets or DMX values). On Page 5 of the chase generator,
you can extend the list of parameters to be assigned to a
chase.
We use a shutter chase as example to explain Page 5 of the
chase generator.
The illustration shows a chase with six steps, which switches
between open and closed.
Step 1:
Fixture 1: open
Fixtures 2 – 6: closed
Step 2:
Fixtures 1 and 3-6: closed
Fixture 2: open
The shutter switches in each step of the chase between open and closed.
You have now the possibility, for example, to programme an additional color to a colour chase. For this
purpose, use the three softkeys described below:
LIST - :
recalls the previous step in the list
LIST+ : recalls the next step in the list
COPY : copies data from one step to another
Use the softkeys LIST- and LIST+ to select the step to which the colour parameter should be added.
Select the desired preset with the corresponding softkey or enter the DMX value with the encoder wheels.
In this example, the colour green was added to chase step 2.
The chase is now structured as follows:
Step 1:
Fixture 1
: colour red
Fixture 2 : colour green
Fixtures 3-6: colour blue
Step 2:
Fixture 1
: colour blue
Fixture 2 : colour red
Fixture 3 : colour green
Fixtures 4-6 : colour blue
Copying the parameters of one step:
Activate the desired chase step with the softkeys LIST- or LIST+. Press and hold the softkey COPY,
select the chase step, on which you want to store the copied step, with the softkeys LIST- or LIST+. The
values are adopted immediately and shown on the display.
You can assign a different DMX value or preset parameters to each step.
Press the STORE key in the Combi section to store the process. After a short time, the display returns to
the PROG COMB CHASE menu. Here you can programme further parameters.