JB-Lighting Licon 1X - Manual (Page 12)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 12 -
Clear the fields with the arrow key first and enter your data.
The individual fields have the following function:
NAME: names the moving light, a maximum of 20 characters is possible.
S-NAME: short name shown on the display later, up to 6 characters are possible.
TYPE: selects between mirror scan (  Mirror) and moving head ( HEAD). To select type,
press key TYPE until the desired fixture type is shown on the display. This affects only
moving patterns.
DMXCH: indicates number and configuration of the DMX channels of the fixture. Per fixture, 25
control channels and 7 fixed-value channels are available. Control channels are standard
DMX channels such as pan, tilt, iris, colour, gobo, focus. Fixed-value channels are DMX
channels with a fixed DMX value (cannot be changed during programming). If, for
example, your fixture has a channel for the parameter lamp on/off, which is a constant
value, then this channel is stored under „fixed“ and assigned the corresponding DMX
value.
Press one of the softkeys described above and the menu on the
left appears on the display.
Now assign the individual functions of your fixture to the DMX
channels as follows: turn the middle encoder wheel (FUNC) until
the desired function appears and then turn the left encoder
wheel (DMXCH) to switch to the next DMX channel. The names
of the individual functions correspond to the names of the keys in
the Feature Selection block, where the parameters will be
activated later. The left encoder wheel (DMXCH) can only switch
forward by one DMX channel. If this channel is not occupied in
the fixture, i.e. is not assigned to a function, you can skip this
channel by pressing the the softkey SKIP.
To invert a DMX channel, select the function first and then press the softkey INVERS (this does not apply
to pan and tilt movements).
Since the Licon 1X has a separate dimmer and shutter management, you are required to make an
additional assignment when you enter the dimmer or shutter channel.
 Fixtures with dimmers and shutters on one channel:
Assign a DMX channel to the shutter, then press the softkeys BRIGHT and BLACKO to assign the
dimmer and the s hutter function to the same channel. In the line next to the shutter, the letters B and O
will appear in addition on the display.