JB-Lighting Licon 1X - Manual (Page 82)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 82 -
16. Editing sequences
In order to edit sequences, proceed as described below:
Press the ESC key time and again until you have entered the
main menu.
Then press the EDIT key in the Combi section (LED is lit).
Select the desired sequence by pressing the corresponding
sequence key.
The following display is shown:.
All parameters of this menu have already been dealt with in
Chapter 15.
 Cf. Chapters 15.1 to 15.14
Press the softkey MODIFY and the following menu is shown on the display:
16.1 The BLOCK function
You can combine several sequence steps to a block that can be either deleted or copied afterwards.
If you have, for example, a sequence that consists of 10 steps, you can define steps 2 to 5 as block and
copy this block to another position within the sequence.
You can use the BLOCK function to delete individual steps of your sequence. Define these steps as block
and then press the Delete key.
Defining a block:
A block can be formed of steps that are arranged consecutively in your sequence. Move the cursor in the
PROG COMB CHASE matrix to the first step you wish to integrate in the block. Press and hold the
softkey BLOCK (field on the display is shown inverted). Turn the middle encoder wheel until you have
reached the last step to be integrated in the block. Release the softkey BLOCK again. All steps integrated
in the block are marked with a B on the display.
This process is additionally shown as graph on the display.
The illustration shows that the block of our example contains a total of your steps (step
2 to step 5).