JB-Lighting Licon 1X - Manual (Page 117)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 117 -
24. Performing a software update (via a PC system)
The software updates are made available directly by the company JB-lighting and can be obtained either
by e-mail or by download from the service section at
http://www.jb-lighting.de . Since the Licon 1X is often
purchased at wholesale, your e-mail address is not automatically in the distributor of JB-lighting. If you
wish to be included in our mailing list, please call us ++49 (0)7304 9617-0 or notify us under
sales@jb-
lighting.de Please always specify your Licon 1X serial number so that the updates are managed correctly.
24.1 Quick installation and configuration guide for the Licon 1X UPDATER
24.1.1 Installing the Licon 1X Updater programme
Download the Licon 1X Updater from the JB-lighting hompage under www.jb-lighting.de or have the Licon
1X Updater sent to you by e-mail.
Store the programme on your PC syste, and save all data of your Licon 1X on a disc or a memory stick.
Then click the setup.exe and follow the instructions of the installation software.
24.1.2 Recalling the Licon 1X Updater
1. Start menu --> Programmes --> JB LICON 1X Updater
24.2 Updating the Licon 1X
!!! CAUTION !!!
!!! Data in the Licon 1X will be lost once the update process is performed!!!
!!!
 It is therefore absolutely necessary to perform a data BACKUP on a disc or a memory stick
before you start the update process!!!
The Licon 1X will be completely reset to factory settings!!!
Use the USB cable to connect the Licon 1X with the corresponding COM port of the PC. The suitable
USB cable is included in the delivery. If not, please contact your local dealer.
Press and hold the no. 8 in the Fixture-/PAR Selection of the
Licon 1X in the OFF-state of the console and simultaneously
turn the console on with the ON/OFF key.
 Now, the LED of key 1 is off and the LEDs 2-8 are lit.
 In additon, the Updater programme displays the message
LICON 1X on the PC.
 If this message does not appear, connect the USB cable to another COM port and repeat the
procedure.
Click the button „START UPDATE“ and select the updater software that you have stored on your PC
beforehand. Start the software transfer to the Licon 1X by opening the Updater software.
The data transfer may last up to 2 minutes. When the update process is completed, the Licon 1X is
turned on automatically.