JB-Lighting Licon 1X - Manual (Page 13)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 13 -
 Fixtures with separate channels for dimmers and shutters:
Assign a DMX channel to the shutter and then press the softkey BLACKO. In the line next to the shutter,
the letter O will appear in addition on the display.
Assign a DMX channel to the dimmer and then press the softkey BRIGHT. In the line next to the dimmer,
the letter B will appear in addition on the display.
The entry of these parameters will ensure that you can later control the brightness of your moving lights
with the fixture faders.
When a fixed-value channel is entered, first of all three times a zero will be shown on the display next to
the term „fixed ..“. You can now enter a value with the right encoder wheel (VALUE). This value is fixed
and cannot be changed later during programming of shows (e.g. for lamp on/off commands).
INVERS
inverts DMX channels. If, for example, the iris of a fixture is built in such a way that it is
open at a DMX value of 0 and closed at 255, you can invert the entire channel with the
softkey INVERS. After inversion, the iris is closed at a DMX value of 0 and fully open at
255.
Press the softkey CLEAR to delete the entries shown inverted on the display.
 Press the ESC key to leave this menu.
P-ANGL
enters the maximum deflection angle (pan movement) of the fixture to be configured. Use
the right encoder wheel to enter data. This is an important parameter, if you wish to work
with preprogrammed moving patterns later. Wrong or missing data of the P-ANGL will
possibly affect circular movements of the fixture.
T-ANGL
enters the maximum deflection angle (tilt movement) of the fixture to be configured. Use
the right encoder wheel to enter data. This is an important parameter, if you wish to work
with preprogrammed moving patterns later. Wrong or missing data of the T-ANGL will
possibly affect circular movements of the fixture.
BLACK-L
enters a value between 0 and 255 with the middle encoder wheel. This value determines
the fader position, at which the blackout will be activated (blackout level).
Important: do not select the DMX value 255!!!
 Press the ESC key to leave this menu.