JB-Lighting Licon 1X - Manual (Page 19)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 19 -
In the example to the left, the DMX channel 1 of the external
console controls CUE1 of the Licon 1X.
Important:
If the function field DIRECT is not displayed inverted, access is only possible to Page 1, Bank A, when
cue, chase and sequence keys are assigned.
If the function field DIRECT is displayed inverted, access is also given to cues, chases and sequences
that are stored on the other pages or banks.
2.9 EXTTRG / Remote control via external trigger input
With the external trigger function, two different keys can be activated by a footswitch. The external trigger
function is only possible in the Combi section.
2.9.1 Assigning keys independent of PAGE/BANK
Press the softkey EXTTRG to activate the corresponding menu. The following display is shown:
Use the middle encoder wheel to select either GO – or GO + .
These designations are placeholders for the key to be
assigned.
When you have selected either GO – or GO + press the key,
which you want to remote-control later, with the footswitch.
The assignment is also shown on the display.
If you have, for example, assigned the Cue key CUE6 to the command GO – , the following is shown on
your display:
If your footswitch is equipped with two switching functions, you can also assign a key to the second GO
function. Use the middle encoder wheel and select the second GO function. Repeat the procedure as
described above.