JB-Lighting Licon 1X - Manual (Page 51)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 51 -
10. The follow function
The follow function allows you to define and move fixtures as follow spots independent of activated cues,
chases or sequences. The fixtures defined as follow spots will only react to PAN and TILT values
received from a connected trackball.
10.1 Programming the follow function
In order to be able to program the follow function, press any key of the Feature Selection section first.
Then press and hold the Follow key and select the fixtures you wish to use as follow spots (corresponding
LEDs are lit).
+
10.1.1 Activating the follow function
Activate the follow function by pressing and holding the Follow
key in the Feature Selection block. The softkey ACTIVE appears
on the display. Press this softkey to activate the follow function.
The function field on the display is shown inverted when the
function is active.
10.1.2 Deactivating the follow function
Press and hold the Follow key. Press the softkey ACTIVE in addition. The follow function is deactivated
when the function field on the display is no longer shown inverted.
10.1.3 Deleting the follow function
To delete the follow function in a cue, enter the Edit mode and activate the corresponding cue. Press the
Edit key in the Combi section and then the cue key, on which the cue is stored.
The AUTOFOL function field on the display is now shown inverted. Press the corresponding softkey. The
follow function (AUTOFOL) is deleted, when the softkey is no longer displayed inverted.