JB-Lighting Licon 1X - Manual (Page 68)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 68 -
11.2.6 Page 6 of the chase generator (modifying chase patterns)
On Page 6 of the chase generator you can modify programmed chase patterns. Press softkey OPTIONS
and the parameters of the chases will be displayed.
The individual fields have the following function:
CH:COMB 1/D04:
storage place of the chase
(here: PAGE 1, Bank D, chase key 4)
TYPE: >------------- flow mode of the chase
(symmetrical, asymmetrical, double
symmetrical)
LENGTH:
number of chase steps
(in this example: 6)
FADE: ON/OFF
This parameter means that the fadetime ramp was
set in the storage matrix. You can assign a fadetime
to this chase.
DIR---->: The direction of the chase pattern is, for example, from left to right.
FLIPLINE: This parameter indicates that the chase pattern runs to the last step and back again.
TYPE:
By pressing the softkey TYPE you can switch the chase patterns between
symmetrical, asymmetrical, double symmetrical, double asymmetrical, four times
symmetrical and four times asymmetrical, which is shown on the display as follows:
>----------- ; >-----------< ; >------>------ ; >---< >---< ; >---->---<-----< ; >->--->->
LENGTH
Length stands for the number of individual chase steps your chase contains. This parameter can be
changed with the middle encoder wheel (LENGTH).
FADE
If the softkey FADE is displayed inverted, a fadetime can be assiged to this chase fader. In order to
switch the chase via the trigpoint time, press the softkey FADE. The softkey is no longer displayed
inverted and the message OFF appears in the Fader section.
DIR
The field DIR will show the direction of the chase. If the softkey DIR is displayed inverted, the chase runs
in one direction. Press the softkey DIR (softkey is no longer displayed inverted) and the chase runs in the
opposite direction.
Confirm the storage process and leave the menu by pressing the Store key in the Combi section again.