JB-Lighting Licon 1X - Manual (Page 62)

JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein Telefon ++49(0)7304 9617-0
- 62 -
Example:
The chase addresses 6 fixtures.
ON value: shutter is open.
OFF value: shutter is closed.
In the first chase step, the shutter of fixture 1 is open, whereas the shutter of
the other five fixtures is closed.
In the second chase step, the shutters of fixtures 1, 3, 4, 5 and 6 are closed,
whereas the shutter of fixture 2 is open.
In the third chase step, the shutters of fixtures 1, 2, 4, 5 and 6 are closed,
whereas the shutter of fixture 3 is open, etc.
11.2.3 Advanced programming with the chase generator (CREATE)
The following chapters will deal in more detail with the functions of the chase generator. To simplify
matters for you, we will describe the functions of the chase generator on the basis of its pages 1 to 6.
When the chase generator is activated as described in Chapter 11.1, you can switch the pages with the
softkeys located in the left and right lower part of the display. They are marked with the arrows „>>>“ or
„<<<“. Next to the arrows, the page is indicated that is presently displayed, e.g. 2 (6) means that page 2
of a total of 6 pages is active.
11.2.3.1 Page 1 of the chase generator (preset selection)
The centre of this page displays a Short Manual in English, which specifies the working steps of Chapter
11.1 Basic programming with the chase generator.
In addition, this page displays the presets that were previously
stored for the activated feature (in our example for the shutter).
You can select another feature by pressing the corresponding
key in the Feature Selection block.
The presets are shown in the upper and left fields of the display
and can be activated by pressing the assigned softkeys. If more
presets are stored than can be shown on the display, use the
softkey „<<<“ to switch to the other preset pages.
The chase steps switch from the ON values to the OFF values (according to the chase pattern), which are
described in more detail in Chapter 11.1.1.
Now enter the ON value:
Press the softkey ON until is is displayed inverted.
Then press one of the softkeys, to which a preset is assigned, or enter the DMX data with the encoder
wheels.
Subsequently enter the OFF value:
Press the softkey OFF until it is displayed inverted. (The inversion of the softkey ON is simultaneously
deleted.) Then press one of the softkeys, to which a preset is assigned, or enter the DMX data with the
encoder wheels.