Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 25)

24 CHAPTER 2 • JOB LIST PAGE
Figure 2.8 – Events Section
The first section, labeled “Events that will trigger this job,” shows the events currently con-
figured for this job. It has the following three sections:
˽ Name – Gives the name of the event. Clicking on the name will allow you to edit the
event.
˽ Description – Explains what the event is.
˽ Remove – Allows you to remove the event, provided you have the necessary privileges.
The second section, Edit Event, is divided into three tabs. The Scheduled Time allows you to
define a time to run the job. The user options are broken into basic and advanced sections.
Figure 2.9 – Basic Time Schedule
The Basic tab is used to schedule a job to run on a recurring basis of seconds, minutes or
hours (see Figure 2.9). Choose the appropriate time increment, enter the value and click the
Add button. The increments will automatically be started based on the top of the current
hour.
Example
If at 1:23 p.m. a new schedule were set to run every 30 minutes, then it would trig-
ger at 1:30 p.m. and continue in 30-minute intervals thereafter.