Wavetronix Command Translator (CMD-DT) - User Guide - Manual (Page 48)

CHAPTER 4 • ROUTES PAGE 47
Figure 4.13 – Edit Asset Group
To add an asset manually, push the Add Asset Manually button to display the Add Asset
window (see Figure 4.14).
Figure 4.14 – Add Asset
Enter a unique name (must be unique) and a mile marker designation (decimal values are
allowed). Then choose an asset type from the drop-down menu. Assets can be classified into
four different categories:
˽ Point
˽ Trap
˽ Delay
˽ Probe
Asset category does not matter for the purpose of creating a route; it is only an indication of
what kind of traffic data is available from that device when the trip time data is calculated.
If the data asset detects vehicle speed (radar, cameras, traffic loops) it is a “Point” device.
Other assets that track individual vehicles over time (toll plazas, for example) will be classi-
fied as Trap, Delay, or Probe data.
Push Save to add the asset to the asset group.
To add an asset directly imported from a Collector installation, push the Add Collector As-
set button below the grid to display the Select Collector Sensors window (see Figure 4.15).