Wavetronix SmartSensor Matrix (SS-225) - User Guide - Manual (Page 73)

72 CHAPTER 7 • LANES & STOP BARS
Saving the Configuration
After automatic and manual configuration is complete, click the Save Config button to save
the changes to the sensor. If you attempt to leave the Lanes & Stop Bar view before saving
your changes, the following prompt will appear (see Figure 7.8).
Figure 7.8 – Save Changes Dialog
Moving the Sensor View
The SSMM software shows the position of the SmartSensor Matrix and the view is drawn
from the perspective of the sensor. If the perspective in the software does not match your
perspective of the roadway, click the Rotate View button until the sensor position matches
the approach you are configuring.
Note
Moving the sensor in the software will have no effect on the sensor’s performance.
Its purpose is to facilitate the configuration process.
Restarting Auto Lane Config/Rebooting the Sensor
Restarting the automatic lane configuration will erase any auto-configuration information
that may have been gathered and will start the auto-configuration process over again.
Rebooting the sensor will also erase any auto-configuration information, but in addition
will clear and reconfigure the sensor thresholds.
Follow the steps below to restart the automatic lane configuration process or reboot the
sensor:
1 Click the Restart/Reboot button and the Restart or Reboot window will appear (see
Figure 7.9).
2 Select the appropriate radio button and click OK.