Datalogic QuickScan I QD2400 - Manual (Page 216)

Enter/Exit Programming Mode
206 QuickScan™ I QD24XX/QBT24XX/QM24XX
Micro QR Code Set Length 1
Specifies one of the bar code lengths for Micro QR Code Length Control on page 205 . Length 1
is the minimum label length if in Variable Length Mode, or the first fixed length if in Fixed
Length Mode. Characters can be set from 0001 to 0035 characters in increments of 0001 (pad
with zeroes).
See
page 251 for detailed instructions on setting this feature.
$CMQL1
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT 0001 = Length 1 is 1 Character