Datalogic QuickScan I QD2400 - Manual (Page 78)

Enter/Exit Programming Mode
68 QuickScan™ I QD24XX/QBT24XX/QM24XX
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4 character pairs
represented in hexadecimal ASCII values. The first character in the pair is the character that will
be converted. The second character in the pair is the character to convert to. If the character to
convert in a pair is FF, then no conversion is done.
NOTE
$CLFCH
Configure Character Conversion
DEFAULT 0xFFFFFFFFFFFFFFFF
(No character conversion)
If less than the expected string of 16 characters are selected, scan the ENTER/EXIT bar
code twice to accept the selections and exit Programming Mode.