Datalogic QuickScan I QD2400 - Manual (Page 27)

Configuring the Base Station
Product Reference Guide 17
Linking to a PC in Client Mode (BT Master Mode)
The reader can optionally be linked in client mode to a Bluetooth-enabled PC with the serial
port profile. To do this, follow these steps:
1. Ensure the PC or terminal can network with Bluetooth devices and that it is powered on.
2. Ensure that a COM port is assigned under Services within the Bluetooth setup menu.
3. Create a Link label that contains the address of the PC Bluetooth adapter.
NOTE
The Bluetooth address can be found under "Properties" within in the Bluetooth setup
menu.

The link label is a Code 128 function 3 label with the following format:
<FN3 char>LnkB<12 character Bluetooth address>
4. Scan the link label you created in step 3.
Linking to a PC in HID mode
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the
Link to PC in HID
label below.
3. Use the host computer’s Bluetooth manager to “Discover new devices” and select "Data-
logic Scanner." If you receive an error message, it may be necessary to disable security on
the device.
4. Use a text editor to see incoming data on the port designated by the computer's Bluetooth
manager.
Link to PC in HID
NOTE
Virtual Keyboard
Once the reader has been connected to an Apple® iPad, smart
phone, or laptop via HID mode, you can toggle the virtual keyboard
on the host by double pressing the trigger within 0,5 second. This
feature is only supported on Apple devices.
Power Off
Shuts off power to the BT handheld until the next trigger pull. This function only applies to the
BT model.
PowerOff