Rear panel – Roland OCTA-CAPTURE - High-Speed USB Audio Interface User Manual
Page 12
12
Rear Panel
10
11
12
13
15
17
16
14
10.
DC IN jack
Connect the DC plug of the included AC adaptor to this jack.
*
Do not use anything other than the included AC adaptor; doing so will cause malfunctions .
11.
Ground terminal
Depending on the circumstances of a particular setup, you may experience a discomforting
sensation, or perceive that the surface feels gritty to the touch when you touch this device,
microphones connected to it, or the metal portions of other objects, such as guitars. This is due to
an infinitesimal electrical charge, which is absolutely harmless. However, if you are concerned about
this, connect the ground terminal with an external ground. When the unit is grounded, a slight hum
may occur, depending on the particulars of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or an authorized Roland distributor, as listed on
the “Information” page.
Unsuitable places for connection
•
Water pipes (may result in shock or electrocution)
•
Gas pipes (may result in fire or explosion)
•
Telephone-line ground or lightning rod (may be dangerous in the event of lightning)
12.
Digital input/output jacks
COAXIAL IN (9/10) jack
Use this when you want to digitally input a two-channel (stereo) signal.
Use this jack when two OCTA-CAPTURE units are connected (p. 63).
COAXIAL OUT (9/10) jack
Use this when you want to digitally send a two-channel (stereo) signal to a digital audio device.
Use this jack when two OCTA-CAPTURE units are connected (p. 63).
927