Compressor parameter settings – Roland OCTA-CAPTURE - High-Speed USB Audio Interface User Manual
Page 58
58
Compressor parameter settings
3
2
5
4
1
1
1
1.
Use the CHANNEL [
] or [
] buttons to select a channel, and then press the [
]
button to access the COMP screen for the channel you want to edit .
2.
Turn the [CURSOR/VALUE] knob to move the cursor to the parameter that you want to
edit .
Setting
Explanation
THRS
Specifies the signal level at which the compressor will begin operating.
GAIN
Adjusts the output level of the compressor.
GATE
Signals lower than this value will be muted.
ATK
Specifies the time from when the input level exceeds the threshold level until the compressor
begins operating.
REL
Specifies the time from when the input level falls below the threshold level until the compressor
stops operating.
RATO
Specifies the compression ratio at which the audio signal will be compressed.
LINK
If this setting is on, the settings of the adjacent channel will be set so they’re identical to those of
this channel.
[
Returns you to the previous screen.
3.
Press the [CURSOR/VALUE] knob to highlight the value .
4.
Turn the [CURSOR/VALUE] knob to edit the value .
5.
Press the [CURSOR/VALUE] knob to confirm the value .
Input level
Gain Reduction