Gefen EXT-MFP Audio/Video Multi-Format Processor - Manual (Page 244)

page | 234
A
dv
anc
ed Oper
ation
Commands
#factory_reset
Reset the Multi-Format Processor to factory-default settings. The Multi-Format Processor
must be power-cycled after executing this command.
Syntax
#factory_reset
Parameters
None
Example
#factory_reset
UNIT IS SET TO FACTORY DEFAULTS
INPUT SET TO HDMI
ASPECT RATIO SET TO SOURCE
PICTURE CONTRAST SET TO 50
PICTURE BRIGHTNESS SET TO 50
PICTURE HUE SET TO 50
PICTURE SHARPNESS SET TO 0
HDMI INPUT HDCP IS SET TO ON
OUTPUT COLOR SPACE OF OUTPUT 2 SET TO RGB 444
OUTPUT MODE OF OUTPUT 1 SET TO AUTO
OUTPUT MODE OF OUTPUT 2 SET TO AUTO
BACKGROUND COLOR SET TO BLUE
PICTURE COLOR RANGE SET TO LIMITED
OVER/UNDERSCAN SET TO OFF
AUDIO INPUT SET TO SOURCE
COMP AUDIO LINKED TO LR2
UNIT IS SET TO FACTORY DEFAULTS
IP MODE SET TO STATIC
A REBOOT IS REQUIRED TO APPLY CHANGES
Important
This command also resets the IP address to “Static” 192.168.1.72. If the IP
address has changed, this will disconnect the Multi-Format Processor from the
network. Use the Gefen Syner-G Discovery Tool to locate the Multi-Format
Processor and assign the new network settings to work on your network.
A
dv
anc
ed Oper
ation