Emerson OXYMITTER 4000 - Manual (Page 3)

HIGHLIGHTS OF CHANGES
Effective December, 2003 Rev. 3.0
Page Summary
Cover Updated photo, revision number, and date.
P-3 through P-14 Added foreign language versions of ‘Safety Instructions for the Wiring
and Installation of this Apparatus’.
P-22 Revised Figure 1 to include remote electronics versions.
1-1 Revised para. 1-2a to include Local operator Interface (LOI) and Model
375 communicator. All IB references to HART Model 275 changed to
read ‘HART Model 275/375’.
1-2 Revised Figure 1-1 to include Oxymitter 4000 with remote electronics.
1-3 Revised para. 1-2c to include reference to remote electronics version.
1-4
Revised para. 1-2d to include differences between units with LOI versus
membrane keypad and to include new Figure 1-3 and Figure 1-4 views.
1-6 Revised NOTE to include LOI operating temperature data.
1-7 Revised Figure 1-7 to include remote electronics versions.
1-14, 1-15 Revised para. 1-7 Specifications to include LOI data, update electronic
noise data, temperature range data, and certification references.
1-16, 1-17 Revised Table 1-1 Product Matrix to update Communication Options and
Calibration Accessories, and to include Probe-to-Electronics Cables.
2-1 Revised para. 2-1a to reference remote electronics version and LOI.
2-4 Revised Figure 2-3 to indicate the integral electronics version is shown.
2-9 Added para. 2-1c to discuss mounting of remote electronics version.
2-12 Added new para. 2-3 for installing remote electronics version.
3-1 Revised section heading to denote configuration instructions applicable
to membrane keypad version only.
3-2 Revised para. 3-1e.4 to define new voltage selection parameters.
3-3 Revised Figure 3-2 to update default parameter settings.
3-5, 3-6 Revised para. 3-3a to correct mA signal level values. Moved power up
procedure to Section 5.
4-1 through 4-6 Added new Section 4 to discuss unit configuration with the LOI. Previous
Section 4 is now Section 5.
5-1 Revised section heading to apply to membrane keypad version only.
6-1 through 6-6 Added new Section 6 to discuss Operation with the LOI. Previous
Sections 5 through 11 are now Sections 7 through 13.
8-1 Added new Figure 8-1 and related overview discussion.
8-3 Revised para. 8-5 to include reference to LOI error indications.
8-4 Corrected mA signal level values in notes for Table 8-1. Added Table 8-2
to identify to LOI fault/alarm messages.